To successfully install a Latch R the following tools are necessary:
- Hardware Installation
- 12-24 VDC power supply
- Drill
- 3/16” drill bit
- 1 ½” drill bit
- Wire stripers
- Wire connectors
- Electrical tape
- T20H x 100 Security bit
- External relay board (not mandatory might be necessary for retrofit installations)
- Activation
- 64 bit iOS device
- Latest version of the Latch Manager App
- M Series (Generation 2) is capable of wired power and compatible with both doorloops and power through hinges. For more details, reference the Installation Guide.
To successfully install a Latch M the following tools are necessary:
- Door Preparation (not necessary if the door is pre-cut in accordance with the appropriate cut sheets by the door manufacturer)
- Drill
- Assortment of drill bits. (Refer to the cut sheets or the template in the box, for correct sizes)
- Hardware installation
- Phillips head screwdriver
- 3/32 Allen wrench (To reverse handing if necessary included in Latch M box)
- Programing
- 64 bit iOS device
- Latest version of the Latch Manager App
To successfully install a Latch C the following tools are necessary:
- Door Preparation (not necessary if the door is pre-cut in accordance with the appropriate cut sheets by the door manufacturer)
- Drill
- Assortment of drill bits. (Refer to the cut sheets or the template in the box, for correct sizes)
- Hardware installation
- Phillips head screwdriver
- Programing
- 64 bit iOS device
- Latest version of the Latch Manager App